- ページ 2

室内装飾品 Higuera Bamboogle BRAZIL CoffeeのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Higuera Bamboogle BRAZIL Coffee 5 ページ。

ページを印刷する

TOOLS REQUIRED:

TIME REQUIRED:

1 Lay out all parts in like groups

2 Prepare the leg & side rails to attach together

3 Complete the leg & rail assembly, which makes a table frame with no top

4 Attach to top to the leg & rail assembly

5 Hand tighten if necessary (do not use a drill)

1 Lay out all parts in like groups

Call us immediately for damaged or missing parts. Its rare, but it happens.

The

disk bushing

with the Phillips head will go in the rails, the

The 8

screws

attach the rail / leg assembly to the table top

2 Prepare the leg & side rails to attach together

Legs

Screw 4

leg pin bolts

Lightly hand tighten each leg post bolt using a slot screwdriver (don't slip & scratch!)

Each leg gets 4, so attach all 16 to the four legs

Rails

The

disk-like tightening bushings

and have the screwdriver X facing toward you

The holes on the side need to face the end of the rails (to receive the

You can leave the

Slip one of the

disks

If you pushed the

notch & X

(Phillips tightening

3 Complete the leg & rail assembly, which makes a table frame with no top

Make one end, then the other end, then add the long rails to complete the frame

Make one end:

Slide the shorter rail onto each leg post bolt on both legs making one end of the table

If the posts won't slide on all the way, check two things:

Unscrew the Phillips-head tightening bullet to give clearance inside the bushing

Or turn the bushing by the notches to line up the hole better

(once you get it, it's a beautiful fit)

Hand tighten the Phillips-head bullet which pulls the rails tight to the legs

(if in the rare event that the rail does not pull snugly to the leg, remove that rail

and retighten that leg post bolt to draw it deeper into the leg socket)

Make the other end (repeat the above steps)

Add the long rails to complete the frame (repeat the same steps as above)

4 Attach the underside of the top to the leg assembly

Before setting the table top upside down for final assembly, make sure to pad the

surface of whatever you intend to set it on to avoid any scratches. A towel placed

on a table top, or the floor would work well.

Place the table top upside down on the soft surface

Gently lift the leg & rail assembly upside down as well, and onto the exposed

underside of the table top.

Line up the predrilled holes on the table top (underside) with the predrilled

holes on the underside of the rails.

Hand tighten the 8 screws with a Phillips screwdriver. DO NOT OVER TIGHTEN

5 Hand tighten if necessary (do not use a drill)

Occasionally, you may want to hand tighten all connections to achieve a tight fit.

This should not have to be repeated after assembly is completed, but in some

climates and due to seasonal moisture, retightening these connections is possible.

QUICK OVERVIEW OF ASSEMBLY PROCESS

Slot Screwdriver & Phillips Screwdriver (do not use power drill)

10-20 minutes, 30 if you're new to assembling things

DETAILS OF ASSEMBLY PROCESS

into the

metal female leg sockets

slip into the predrilled holes, but line them up carefully!

Phillips head tightening

bullet in the bushing if you wish

into the predrilled holes using the notches to line it up straight

disk

in but didn't line it up straight, place a slot screwdriver in a

bullet) to turn the entire

leg pin bolt

goes into the legs

already fixed into each leg

leg pin

bolt)

bushing

disk.