- ページ 5
コントローラー AGS Merlin 1000SiのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AGS Merlin 1000Si 12 ページ。 Gas safety products, gas utility controller
AGS Merlin 1000Si にも: ユーザー・インストール・マニュアル (7 ページ), ユーザー・インストール・マニュアル (9 ページ), インストレーション&オペレーションマニュアル (16 ページ)
Merlin 1000Si
2.7 CO2 MONITOR
This terminal can be connected to a CO
the event of a high concentration of CO
If no CO2 monitor is connected, the panel will 'beep' upon power up and
the CO2 LED will flash 3 times to indicate that this terminal has been
disabled.
Refer to your CO
monitor guide for further information.
2
2.8
This is a permanent 12v DC output when there is power at the panel and
can be used to create a relay switch with the BMS relay output.
Contact your supplier for more information.
3
Installation & Operation
3.1
System On and Off
Turn off all open appliances and turn the key switch to on position.
To switch the system off, turn the key switch to off position.
3.2
Emergency Shut Off
The emergency shut off button is located on the front of the panel.
There is also a facility for remote shut off buttons to be wired in series on the circuit board.
The emergency shut off button(s) will cut off the gas supply when activated.
To reinstate the system, the emergency shut off button(s) will need to be reset and the panel
restarted.
Rev: 05
05-19
2.6
FS 1/2/3/4
This terminal switches when the key is turned on and off.
This can be linked to a fan switch (supplied separately) which can provide
power to the fans when the control panel is switched on.
2
.
2
12v DC
monitor to shut off the system in
User Guide
5