AGS Merlin 1000Si Podręcznik użytkownika - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Kontroler AGS Merlin 1000Si. AGS Merlin 1000Si 12 stron. Gas safety products, gas utility controller
Również dla AGS Merlin 1000Si: Instrukcja obsługi i instalacji (7 strony), Instrukcja obsługi i instalacji (9 strony), Instrukcja instalacji i obsługi (16 strony)

Merlin 1000Si

2.7 CO2 MONITOR

This terminal can be connected to a CO

the event of a high concentration of CO

If no CO2 monitor is connected, the panel will 'beep' upon power up and

the CO2 LED will flash 3 times to indicate that this terminal has been

disabled.

Refer to your CO

monitor guide for further information.

2.8

This is a permanent 12v DC output when there is power at the panel and

can be used to create a relay switch with the BMS relay output.

Contact your supplier for more information.

Installation & Operation

3.1

Turn off all open appliances and turn the key switch to on position.

To switch the system off, turn the key switch to off position.

3.2

The emergency shut off button is located on the front of the panel.

There is also a facility for remote shut off buttons to be wired in series on the circuit board.

The emergency shut off button(s) will cut off the gas supply when activated.

To reinstate the system, the emergency shut off button(s) will need to be reset and the panel

restarted.

Rev: 05

05-19

2.6

FS 1/2/3/4

This terminal switches when the key is turned on and off.

This can be linked to a fan switch (supplied separately) which can provide

power to the fans when the control panel is switched on.

12v DC

monitor to shut off the system in

User Guide