- ページ 2
屋外倉庫 Galvo Shed GVO 3023のPDF 組立説明書をオンラインで閲覧またはダウンロードできます。Galvo Shed GVO 3023 8 ページ。 Gable roof shed
ページを印刷するASSEMBLY OVERVIEW
These instructions are designed to guide you though the
process of building your new garden shed. It is a simple
process of joining sheets together before adding top and
bottom channels to form a shed panel. These panels are then
joined together to make you shed as shown simply in diagrams
1, 2 and 3 below.
When fitting the channels to the sheets the high side of the
channel goes on the inside of the sheet, that way any water
that collects in the bottom channel will run over the lower side
and run away rather than into the shed.
DIAGRAM 1
COMPONENTS CHECKLIST
Please check all components carefully and advise your supplier immediately if any discrepancies.
Remember to quote the code on the front page.
A
2 x 1770 x 780mm door sheets
E
4 x 1960mm angle cut sheets &
2 x 2025mm gable cut sheets
(end walls).
I
2 x 2290mm 'U' channels for end
walls (top)
M
4 x 1200mm 'L' flashings
(roof to side flashings)
Q
4 x door bracing
2
DIAGRAM 2
B
2 x narrow 1830 x 715mm sheets
(beside door)
F
4 x 3000mm 'U' channels with
ends cut for front and back walls
J
4 x 1770mm 'U' channels
(door sides)
N
2 x 1830mm & 1 x 1770mm 'Z'
door jambs (front)
R
1 x 3000mm long ridge beam (roof)
Rivets are fitted by drilling through outside of the channel into
the ribs of the sheet, usually at every second rib. It is also
important to fit at least one rivet per sheet from the inside of
the channel into the pan of the sheet, close to a rib. Extra rivets
should be fitted on the inside of the channel into the pan of the
sheets in high wind areas.
It is critical the you remove the swarf (the metal filings
created when drilling) from the panels and channels as
you assemble them as these will rust quickly and cause
corrosion issues with your shed!
DIAGRAM 3
C
4 x 1830 x 780mm (back wall)
G
4 x 3000mm 'U' channels for roof
K
2 x 1586mm 'U' channels
(door spacers)
O
2 x 310mm door plate
S
2 x 2 gable plates for gable ends
If you choose to vary from these instructions your warranty will be impaired
INSIDE
OUTSIDE
PAN
D
8 x 1200mm x 780mm sheets (roof)
H
2 x 2255mm 'U' channels for end
walls (bottom)
L
4 x 780mm 'U' channels (door top
and bottom)
P
1 x pack rivets with padbolts
1 x pack of rivets and hinges
RIB