- ページ 4
屋外倉庫 Galvo Shed GVO 3023のPDF 組立説明書をオンラインで閲覧またはダウンロードできます。Galvo Shed GVO 3023 8 ページ。 Gable roof shed
ページを印刷するSTEP 3
END WALLS
Join the sloping sheets
end wall as shown. Make a cut in the centre (1145mm) of the 2290mm top channel
and cap the three
sheets. Cap the bottom of the sheets with an
I
E
channel. Rivet at corners only for now. Slip
and rivet
into sheeting in the ribs for outside and pans for the inside of the
wall. There should also be 3 rivets up underneath through channel, into pans
of each sheet.
Repeat process to build the other end wall.
underneath through channel into pan of sheet.
Repeat process to build the other end wall.
STEP 4
DOOR ASSEMBLY
Attach the 780mm 'U' channels
centre ribs only. Attach the 1770mm 'U' channels
top and bottom channels
L
Attach the door plate
in the centre of the door sheet, slipping it under the two side
O
'U' channels and fixing it to the sheet ribs and the side 'U' channels.
Attach the hinges
approx 150mm from the top and bottom of the door through the
P
'U' channels. The fixings should be centred on the side 'U' channels.
Turn the door over and fix the four corners through all the 'U' channels.
Perform the same (but mirror image) for 2nd door. Attach 1770mm 'Z' door jamb
to 2nd door onto the
on the same side as the door plate. This "Z" serves as a
J
weather flashing between the doors when they are closed.
150MM
4
together as with previous panels to create a gable
E
gable plate under channel at the top
R
Place 3 rivets up
CHANNELS
Channels will end 15-20mm
short at tops of end walls
and 10-15mm at bottoms.
to the top and bottom of the door sheet
L
to the door sheet
J
at the four corners.
HINGES
The hinges should protrude
over the top of the channel
P
2255mm
H
E
H
at the
A
through the
A
J
O
L
If you choose to vary from these instructions your warranty will be impaired
YOU WILL NEED
E
4 x 1960mm angle cut sheets & 2 x
2025mm gable cut sheets (end walls)
2 x 2255mm 'U' channels (bottom)
H
I
2 x 2290mm 'U' channels (top)
R
2 x gable plates
I
R
YOU WILL NEED
2 x 1770mm x 780mm door sheets
A
J
4 x 1770mm 'U' channels
L
4 x 780mm 'U' channels
O
2 x 310mm door plate
P
Hinges
N
1 x 1770mm 'Z' door jamb
L
A
J
R