- ページ 3
屋外倉庫 Galvo Shed GVO 3030のPDF 組立説明書をオンラインで閲覧またはダウンロードできます。Galvo Shed GVO 3030 8 ページ。 Gable roof shed
ページを印刷する
STEP 1
DOOR ASSEMBLY
Attach the 780mm 'U' channels
centre ribs only. Attach the 1770mm 'U' channels
top and bottom channels
Attach the door plate
in the centre of the door sheet, slipping it under the two side
O
'U' channels and fixing it to the sheet ribs and the side 'U' channels.
Attach the hinges
approx 150mm from the top and bottom of the door through the
P
'U' channels. The fixings should be centred on the side 'U' channels.
Turn the door over and fix the four corners through all the 'U' channels and fit the door
bracing from the bottom corner to the opposite centre to the top corner (step 2 below).
Perform the same (but mirror image) for 2nd door. Attach 1770mm 'Z' door jamb
to 2nd door.
150MM
STEP 2
HANGING THE DOOR
Attach the first 'Z' door jamb
Attach the other 'Z' door jamb to the 715mm sheet. Lay the premade door face down on
the 715mm sheet
approx 30mm up from the bottom and down from the top.
B
Check the door is centralised on the sheet (top and bottom). Fix the hinges through the
side of the 'Z' door jamb
Repeat the procedure for the second door.
4MM
GAP
If you choose to vary from these instructions your warranty will be impaired
to the top and bottom of the door sheet
L
to the door sheet
J
at the four corners.
L
HINGES
The hinges should protrude
over the top of the channel
P
to the 715mm sheet
N
raising the door about 4mm off the 'Z' door jamb.
N
NARROW PAN
30MM
at the
A
through the
A
J
L
on the rib with the narrow pan.
B
YOU WILL NEED
2 x 1770mm x 780mm door sheets
A
J
4 x 1770mm 'U' channels
L
4 x 780mm 'U' channels
O
2 x 310mm door plate
P
Hinges
Q
4 x door bracing
N
1 x 1770mm 'Z' door jamb
O
A
J
YOU WILL NEED
B
2 x 1830mm x 715mm sheet
N
2 x 1830mm 'Z' door jambs
B
N
L
3