- ページ 5

屋外倉庫 Galvo Shed GVO 3030のPDF 組立説明書をオンラインで閲覧またはダウンロードできます。Galvo Shed GVO 3030 8 ページ。 Gable roof shed

STEP 4

BACK WALL

Join the 4 sheets

together with 2 fixings through the overlapping ribs, making

sure the ends of the sheets are flush. Cap the sheeting with the 3000mm

'U' channels

Fix the channels through the end ribs and every second rib in between. Make sure

you put at least one fixing per sheet up through the underside of the channel into

the pan of the sheet.

GALVO TIP

Put extra fixings in for

high wind areas, particularly

on the underside.

STEP 5

ROOF

Join the sheets

together, same as the back. Cap the sheeting with the 3000mm

'U' channels

. Fix the channels at every second rib but not the corners at this stage.

Place the short flange of the first 'L' flashing

Make sure the ends are flush with the sheeting (diagram 1) and put one

fixing in the centre to hold the 'L' flashing. Fix the corners through

the channels and one more between the corner and the centre

fixing. Perform the same at the other end.

Fit the ridge beam

to 1 roof panel only.

Fix through the ends and up through the

internal flange on the underside.

DIAGRAM 1

If you choose to vary from these instructions your warranty will be impaired

on top of the rib at one end.

YOU WILL NEED

4 x 1830mm x 780mm sheets

2 x 3000mm 'U' channels with ends cut

YOU WILL NEED

8 x 1600mm x 780mm sheets

4 x 3000mm 'U' channels

4 x 1600mm 'L' flashings

1 x 3000mm long ridge beam