- ページ 4

エンクロージャー AFL IDEAA 144FのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。AFL IDEAA 144F 14 ページ。

LOCK AND UNLOCK EXTERIOR DOORS

1. Using a standard 216 style tool, or similar, turn the locking bolt located at the center of the IDC door

a ¼ turn clockwise to unlock and counter clockwise to lock the cabinet..

Note: A pad lock, not provided, may be utilized if additional security is desired.

The IDC was designed so that the door may be installed on either side of the cabinet for applications where there are

space restrictions.

1. Lift up on the cabinet door to release it from the hinge pins.

3. Using local engineering practices determine which side of the cabinet the door is to be placed. Install the enclosure

door over the appropriate hinge pins.

3. Review the label and diagram orientation on the IDC door. If necessary, apply the included Replacement Door Label

Kit in the appropriate positioning.

4. Using a standard 216 style socket tool, or similar, lock the cabinet.

Caution: Fiber optic cable is susceptible to damage

from excessive bending, pulling or crushing forces.

At every stage of the installation process ensure that

loose buffer tubes, ribbon or Wrapping Tube Cable

(WTC) with Spider Web

free from unintentional cuts, knick or bends to avoid

potential fiber damage.

1. Mark the cable to have a minimum 60" (152.4 cm) opening.

2. Use local accepted practice to remove the cable sheath.

3. Using wire cutters cut the central strength member back to the sheath opening.

Note: For best practice, when working with WTC it

is recommended accepted local practices be used

to protect the SWR fiber before continuing to the

cable installation.

Ribbon (SWR) fibers are

INSTALLATION INSTRUCTIONS

IDEAA

Interior Distribution Cabinet

60" (152.4 cm)

Specifications are subject to change without notice.