- ページ 7
扇風機 AireGard FS-150のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AireGard FS-150 12 ページ。 Fresh air supply
ページを印刷するINSTALLATION GUIDES
Be careful and take necessary measures to prevent gases from slipping out into the room via any air vent or other
open flames equipment.
Avoid the following situation during installation to prevent from abnormal loud noise or possible drop in wind speed.
(1) Too much bending
Prohibited
4. Wiring the 86 Box Control Kit
Connect the wires for the 86 Box Control Kit to the wire vent
and switch box.
The two ends of the wire has different connecting power plug.
Make sure the right end is connected to the right power plug
for the main unit as well as for the 86 Box Control Kit.
5. Connecting the Cloth Line & 86 Box Control Kit
Connect the Cloth line and the 86 Box Control Kit according to
the Line Schematic Diagram on page 8
Earth
Connecting
Wire
Neutral
Rod
Crimping plate
86 Box Control Kit Wire
B. 86 BOX CONTROL KIT INSTALLATION
1. Remove the back cap
a. Use the Slotted Head Screw Driver to pry
open the back cap of the 86 Box Control Kit
from the side as indicated in the diagram.
b. Pull out the connecting wires from the base of
the 86 Box Control Kit, and pulls it through the
lower cap of the 86 Box Control Kit and secure
the lower cap to the base using screws. Finally
connect tightly the power plug to the circuit
board on the upper cap of the 86 Box Control
Kit.
(2) Multiple bending
Live
Wire
Screws
Power Supply Wire Cap
PRECAUTIONS
(3) Reducing the diameter of the ductings
Prohibited
86 Box Control Kit Wire
86 Box Control Kit Wire
86 Box Control Kit
Power Plug
Remote Control
Interface
Prohibited
To Main Unit
To 86 Box
Control Kit
Copper Wire
Connecting
Earth Wire
Fixed Cloth Line
86 Box Control Kit Base
Screws (M4x16)
86 Box Control Kit Back Cap
Unit (in mm)
page 5