- ページ 9
扇風機 AireGard FS-150のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AireGard FS-150 12 ページ。 Fresh air supply
ページを印刷するINSTALLATION GUIDES
3. Using the "SMART"
Applies for situation where indoor air quality is poor and smart
sensor auto determine on the outdoor air quality.
The "SMART" mode can help to improve the overall air quality
by monitoring outdoor air quality to control amount of inward air
intelligently, while prolonging the Air Filter lifespan .
1) Press the
button to turn on the "PLUS" mode, the wind
default speed is set as "MID"
during this mode function.
2) To turn off the "SMART" mode, press the
time to turn off.
4. Using the "BYPASS"
Applies for situation where there is a urgent need for a fast
change of indoor air, without filtering the air quality.
The "BYPASS" mode improve the overall air quality by reducing
heavy usage on the air filter, thus prolonging the lifespan of the
air filter.
1) Press the
button to turn on the "BYPASS" mode, the wind
default speed is set as "HIGH"
2) To turn off the "BYPASS" mode, press the
more time to turn off.
5. Setting the "SLEEP"
Applies for situation where indoor air cleaning is necessary while
operating in a super quiet condition.
The "SLEEP" mode improve the overall air quality to provide
cleaner indoor air for all.
1) Press the
button to turn on the "DIRECT" mode, the wind
default speed is set as "LOW"
2) To turn off the "SLEEP" mode, press the
time to turn off.
Stop using the unit is any abnormal issues are detected. Contact the dealers or servicing agents
for inspection or technical support.
The default air temperature indicated on the 86 Box Control Kit sets between -9.9 and 50 .
When the sensor is malfunctioning, the air temperature is indicated as "E1"
Yellow / Green
Blue
N
Brown
L
240V ~ 50Hz
Main Current Switch
(not lower than
250V~15A)
86
Box
Control
Kit
Wire Connection
Schematic Drawing
Fresh Air
Temperature
Sensor
Side Valve
Cross Motor
Mode
. The speed is not adjustable
Mode
.
Mode
.
button one more
PRECAUTIONS
Main
Control
Panel
Fresh Air
Motor
M
~
M
M
PM2.5
PM2.5
Main Valve
Sensor
Control Motor
button one more
button one
NOTE :
1. All technical installation and connection works must be
carried out by professional trained technicians.
2. All wires laying and connection must fulfill the basic
requirements of distance allowance for Grade III
standards of maximum power current flow.
3. Use only power switch with permissible rated current
of 15A or more.
4. All wires must be safely insulated with cloth fabricated
cables, with cable diameter not lesser than 2.5mm
5. Strip the wires only within necessary lengths and
connect them accordingly. Over stripped wires may
cause short circuit or fire hazards.
6. Ensure that the outer cap is closed to avoid moisture
that will damage the unit. Avoid press too hard on the
wires when closing the cap.
Filter
Change
Temperature
Wind
Modes
Speed
PLUS
DIRECT
SMART
BYPASS
HIGH
MID
LOW
SLEEP
Filter
Change
Temperature
Wind
Modes
Speed
PLUS
DIRECT
SMART
BYPASS
HIGH
MID
LOW
SLEEP
Filter
Change
Temperature
Wind
Modes
Speed
PLUS
DIRECT
SMART
BYPASS
HIGH
MID
LOW
SLEEP
2
.
page 7