- ページ 15

自転車 Hikobike ENDURO 2022のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Hikobike ENDURO 2022 17 ページ。

5. Torque Settings

All bolt torques should have been checked during the pre delivery inspection (PDI). If

you have done the final assembly yourself please check before you set off for the first

time.

a. Handlebar clamp bolts

b. Headset bolts

c. Stem angle bolt

d. Quick release front axle

halfway through swing from open to fully closed.

e. Seat tube clamp nut

through swing from open to fully closed

f. Seat angle clamp bolt

For reference specific bolts are tightened according to the recommended torques on PDI

With any other bolts, the torque depends on the diameter:

M4 2.5-4.0 Nm

M5 4.0-6.0 Nm

M6 6.0-7.5 Nm

Dos and Don'ts

Do treat your HIKOBIKE like any bicycle you would want to last well. Keep it stored somewhere

secure and away from the elements.

Don't treat your HIKOBIKE as a dirt-bike. The motor and battery are weatherproof, but not water-

tight. It is ok in rain, but not to ford rivers and streams etc

Do take extra care on the road as you will be travelling faster than you normally do on a bike and

your bike is now power-assisted, so will behave differently.

Never take your HIKOBIKE on the beach as salt water and sand will drastically shorten the lifespan

of many of the e-bike's components (motor, gears, wiring connections, etc).

Note: Your warranty is void if evidence of salt, sand, or water damage are present within the

components. Important: If you live very close to the sea you must keep your bike indoors when not

in use. This will save you lots of money as your components will last longer.

Important: Your bike may arrive with the battery partially charged. You need to give it a full

charge before ANY use. Top your battery up after each use (lithium batteries prefer shallow

discharge).

Note: The LCD battery display bars will dip under full load (on hills, etc). This is normal as running

voltage drops under high load. To get an accurate battery reading, wait about 10 seconds after the

motor stops being used.

8 Nm

8 – 10 Nm

15 Nm

Common industry practice is resistance at lever

Common industry practice is resistance at lever halfway

22Nm