ページを印刷するHARDWARE AND PARTS REQUIRED:
(8) 8‐32 STANDARD NUTS
(4) 8‐32 1 ¼" BOLTS
(4) 8‐32 1 ¾" BOLTS
TOOLS NEEDED:
ELECTRIC/SCREW GUN W/ T20 BIT‐ NEEDLE NOSE PLIERS
1. Plug Wires into Controller as Shown in Picture 1 and Slide controller
into slot in Power Housing
2. Route Wires through Power Housing as shown in Picture 2. Make sure
Wires are clear of Power Housing Areas that may lead to pinching.
3. Place Power Sleeve into Power Housing and lower opposite Power
Housing on as shown in picture 3. Make sure Controller, Wires and
Power Sleeve are all aligned in there respective slots.
4. Bolt the housings together, starting with the 1 ¼" bolts in the front
four locations, and finishing with the remaining four in the rear.
3.
Power Housing Assembly / Controller Install
1.
2.