Core CHT 410 Servis Kılavuzu - Sayfa 16

Düzeltici Core CHT 410 için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Core CHT 410 16 sayfaları.

HARDWARE AND PARTS REQUIRED:

(8) 8‐32 STANDARD NUTS

(4) 8‐32 1 ¼" BOLTS

(4) 8‐32 1 ¾" BOLTS

TOOLS NEEDED:

ELECTRIC/SCREW GUN W/ T20 BIT‐ NEEDLE NOSE PLIERS

1. Plug Wires into Controller as Shown in Picture 1 and Slide controller

into slot in Power Housing

2. Route Wires through Power Housing as shown in Picture 2. Make sure

Wires are clear of Power Housing Areas that may lead to pinching.

3. Place Power Sleeve into Power Housing and lower opposite Power

Housing on as shown in picture 3. Make sure Controller, Wires and

Power Sleeve are all aligned in there respective slots.

4. Bolt the housings together, starting with the 1 ¼" bolts in the front

four locations, and finishing with the remaining four in the rear.

Power Housing Assembly / Controller Install