Core CHT 410 Servis Kılavuzu - Sayfa 15

Düzeltici Core CHT 410 için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Core CHT 410 16 sayfaları.

HARDWARE AND PARTS REQUIRED:

‐RIGHT SIDE OF RH GRIP "B"

‐(2) SHAFT CLAMPS

‐(2) 10‐32 5/16 NUT

‐(1) 10‐32 ¾ BOLT

‐(1) 10‐32 5/8 BOLT

‐(4) RIGHT HAND GRIP SCREW

‐TRIGGER

‐TRIGGER SPRING

TOOLS:

‐(2) ELECTRIC/SCREW GUN, T25 AND T18 BITS

1. Place the 5/8" bolt through the shaft clamp hole

on the rear of handle, and the 3/4" bolt through

the shaft clamp on the front part of the handle.

Using the T25 bit, tighten the shaft clamps so the

grip handle is snug to the shaft.

2. Place the lockout lever on the post as shown in

picture 2, with the spring pre‐loaded.

3. Place the Trigger down on it's post with the

spring preloaded, as shown in picture 3.

4. Route wire back to Power Housing and plug wire

connector back into Controller.

Power Housing / Grip Handle Assembly