- ページ 12

スイッチ Maiwe MIEN2206のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Maiwe MIEN2206 14 ページ。 Unmanaged industrial ethernet switch

MIEN2206 Unmanaged Industrial Ethernet Switch

panel flash one at a time, indicating that the switch has been powered on.

When the RUN indicator flashes, the switch starts to work normally.

3.2.5. Copper Port Test

As below picture,Power on the switch, connect any two copper ports to the

network ports of the two test computers through a directly connected network

cable, and send Ping commands to each other. Both parties can correctly ping

each other without packet loss. At the same time, the yellow light on the

corresponding port should be always on (the computer network card works in

100M state) or off (the computer network card works in 10M state), and the

green light on the corresponding port should flash. It means that the hardware

of the tested two copper ports is working normally.

The equipment with optical fiber interface is formed into the optical fiber

chain network as shown in below (TX connects to another RX, RX connects to

another TX). Each copper port of each device is connected to the test

computer through a directly connected network cable, and sends Ping

commands to each other, so that both parties can correctly ping each other

without packet loss. At the same time, the LINK light corresponding to the

optical port should flash, indicating that the hardware of the two optical ports

under test is working properly.

- 8 -