Maiwe MIEN2206 Podręcznik użytkownika - Strona 12
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Przełącznik Maiwe MIEN2206. Maiwe MIEN2206 14 stron. Unmanaged industrial ethernet switch
Drukuj stronę
MIEN2206 Unmanaged Industrial Ethernet Switch
panel flash one at a time, indicating that the switch has been powered on.
When the RUN indicator flashes, the switch starts to work normally.
3.2.5. Copper Port Test
As below picture,Power on the switch, connect any two copper ports to the
network ports of the two test computers through a directly connected network
cable, and send Ping commands to each other. Both parties can correctly ping
each other without packet loss. At the same time, the yellow light on the
corresponding port should be always on (the computer network card works in
100M state) or off (the computer network card works in 10M state), and the
green light on the corresponding port should flash. It means that the hardware
of the tested two copper ports is working normally.
3.2.6. Fiber Port Testing
The equipment with optical fiber interface is formed into the optical fiber
chain network as shown in below (TX connects to another RX, RX connects to
another TX). Each copper port of each device is connected to the test
computer through a directly connected network cable, and sends Ping
commands to each other, so that both parties can correctly ping each other
without packet loss. At the same time, the LINK light corresponding to the
optical port should flash, indicating that the hardware of the two optical ports
under test is working properly.
- 8 -