- ページ 9

回転する車輪 Majacraft AuraのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Majacraft Aura 16 ページ。

Majacraft Aura 取扱説明書
9. Conrods to Pedals
Required:
2 - Gold 25mm (1") screws (in the pedals)
Posidrive screwdriver
Fit the green joiners in the wooden footmen to the pedals. We leave a mark on one conrod (a #1 on the
bottom end) and the right pedal (#1 by the screw hole) to ensure that each conrod is attached to the correct
pedal.
Starting with the right pedal (it will be on your left if you are facing the drive wheel), remove the gold 25mm
screw from the side of the pedal. Choose the conrod with the #1 stamped on the bottom and push the green
joiner through the hole in the pedal. It should protrude through the bottom of the pedal about 1mm-2mm.
Check the alignment of the outer rod end in the crank assembly. When the rod end is aligned correctly, screw
the 25mm screw back into place. The screw should only be tightened until the head just touches the side of
the pedal. DO NOT OVERTIGHTEN!
Now the left pedal (it will be on your right if you are facing the drive wheel), remove the gold 25mm screw
from the side of the pedal. Choose the remaining conrod and push the green joiner through the hole in the
pedal. It should protrude through the bottom of the pedal about 1mm-2mm. Check the alignment of the rod
end in the crank assembly as shown below. When the rod end is aligned correctly, screw the 25mm screw
back into place. The screw should only be tightened until the head just touches the side of the pedal. DO NOT
OVERTIGHTEN!
9a
CORRECT
9c
INCORRECT
9d
9
9b
9e
majacraft