Majacraft Aura Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wirujące koła Majacraft Aura. Majacraft Aura 16 stron.

9. Conrods to Pedals

Required:

2 - Gold 25mm (1") screws (in the pedals)

Posidrive screwdriver

Fit the green joiners in the wooden footmen to the pedals. We leave a mark on one conrod (a #1 on the

bottom end) and the right pedal (#1 by the screw hole) to ensure that each conrod is attached to the correct

pedal.

Starting with the right pedal (it will be on your left if you are facing the drive wheel), remove the gold 25mm

screw from the side of the pedal. Choose the conrod with the #1 stamped on the bottom and push the green

joiner through the hole in the pedal. It should protrude through the bottom of the pedal about 1mm-2mm.

Check the alignment of the outer rod end in the crank assembly. When the rod end is aligned correctly, screw

the 25mm screw back into place. The screw should only be tightened until the head just touches the side of

the pedal. DO NOT OVERTIGHTEN!

Now the left pedal (it will be on your right if you are facing the drive wheel), remove the gold 25mm screw

from the side of the pedal. Choose the remaining conrod and push the green joiner through the hole in the

pedal. It should protrude through the bottom of the pedal about 1mm-2mm. Check the alignment of the rod

end in the crank assembly as shown below. When the rod end is aligned correctly, screw the 25mm screw

back into place. The screw should only be tightened until the head just touches the side of the pedal. DO NOT

OVERTIGHTEN!

CORRECT

INCORRECT

majacraft