- ページ 15

インバーター Afore HNS3000TLのPDF ユーザーマニュアルインストールをオンラインで閲覧またはダウンロードできます。Afore HNS3000TL 17 ページ。 Pv inverter single mppt

6 Commissioning

After completing the mechanical and electrical installation, the inverter is put into

operation.

1. Switch on the DC and AC breakers.

The inverter starts up automatically when the power from PV generator is sufficient.

2. Check whether the display and LEDs are indicating a normal operating state.

Green

Red & LCD backlight

The typical connection diagram for the entire PV system is shown in the following

figure.

1. PV Panel: Provide DC power to inverter

2. Inverters: Converts DC (Direct Current) power from PV panel(s) to AC (Alternating

Current) power. Because Inverter is grid-connected it controls the current amplitude

according to the PV Panel power supply. Inverter always tries to convert the

maximum power from your PV panel(s).

3. Connection system: This "interface" between Utility and PV-Inverter may consist of

electrical breaker, fuse and connecting terminals. To comply with local safety

Glowing, operation

Flashing, contact installer

13 / 15