- ページ 9

配管製品 Bristan DSC WMBF CのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Bristan DSC WMBF C 16 ページ。 Descent tap range
Bristan DSC WMBF C にも：インストール手順とユーザーマニュアル (18 ページ)

ページを印刷する

Installation

3 Hole Basin Mixer/ Bath Filler

1. With the backnut, metal and rubber washer

fitted to the side body threaded tail, put the side

body through the hole in the basin / bath from

underneath.

2. Screw the shroud, ensuring the washer is

fitted betweed the shroud and basin / bath, onto

the treaded tail and tighten backnut

underneath onto the bottom of the basin/

bath. The screws on the backnut allow for any

uneven surfaces and should be tightened up to

metal washer. Replace the handle, grub screw

and the cap.

3. Fit the spout to the basin/ bath tightening the

backnut. The screws on the backnut allow for

any uneven surfaces and should be tightened

up to metal washer.

4. Attach the T- joint assembly and connect to

the side bodies (hot on the left, cold on the right

when viewed from the front), by using the flexi

tails supplied.

5. Connect the hot and cold water supplies

to the side bodies (hot to the left, cold on the

right hand side), fully open both valves, letting

the water flow for a few minutes to flush the

system.

6. Fit the clicker waste (basin mixer only)

ensuring the rubber washer is fitted between

the basin and the waste. Place the other

rubber washer under the basin and secure in

place by tightening the backnut. In order to

fill the basin, the button in the middle of the

waste needs to be pressed down.

To release the water, press the button again.

7. Check all joints and connections

for leaks.

Need help? Give us a call on 0844 701 6273 and speak to one of our trained advisers.