Bristan DSC WMBF C 설치 지침 매뉴얼 - 페이지 9

{카테고리_이름} Bristan DSC WMBF C에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bristan DSC WMBF C 16 페이지. Descent tap range
Bristan DSC WMBF C에 대해서도 마찬가지입니다: 설치 지침 및 사용자 설명서 (18 페이지)

페이지 인쇄

Installation

3 Hole Basin Mixer/ Bath Filler

1. With the backnut, metal and rubber washer

fitted to the side body threaded tail, put the side

body through the hole in the basin / bath from

underneath.

2. Screw the shroud, ensuring the washer is

fitted betweed the shroud and basin / bath, onto

the treaded tail and tighten backnut

underneath onto the bottom of the basin/

bath. The screws on the backnut allow for any

uneven surfaces and should be tightened up to

metal washer. Replace the handle, grub screw

and the cap.

3. Fit the spout to the basin/ bath tightening the

backnut. The screws on the backnut allow for

any uneven surfaces and should be tightened

up to metal washer.

4. Attach the T- joint assembly and connect to

the side bodies (hot on the left, cold on the right

when viewed from the front), by using the flexi

tails supplied.

5. Connect the hot and cold water supplies

to the side bodies (hot to the left, cold on the

right hand side), fully open both valves, letting

the water flow for a few minutes to flush the

system.

6. Fit the clicker waste (basin mixer only)

ensuring the rubber washer is fitted between

the basin and the waste. Place the other

rubber washer under the basin and secure in

place by tightening the backnut. In order to

fill the basin, the button in the middle of the

waste needs to be pressed down.

To release the water, press the button again.

7. Check all joints and connections

for leaks.

Need help? Give us a call on 0844 701 6273 and speak to one of our trained advisers.