- ページ 12

ストリング・マシン Gamma 6004のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Gamma 6004 20 ページ。 6 point mounting
Gamma 6004 にも：オーナーズマニュアル (20 ページ), オーナーズマニュアル (20 ページ), オーナーズマニュアル (19 ページ)

STRINGING THE FRAME

Weaving the Cross Strings

Weave the cross strings over and under the main strings being careful to alternate the weave

direction of each consecutive cross string so as to be opposite of the previously installed

cross string.

Once the ﬁ nal cross string is tensioned and clamped, tie off at the appropriate hole speciﬁ ed

by the racquet manufacturer. Remove the frame from the mounting system by loosening the

shoulder supports and frame supports.

Pulling Tension

Wrap the loose section of string once around

the roller and insert the string between the

diamond dust coated string gripper plates.

Pull the string perpendicular to the gripper

plates while slowly rotating the tensioner

crank clockwise until the brake lever pops

out of the latching block. The string is now

tensioned and can be clamped in place with

the remaining ﬁ xed clamp.

Repeat the above steps until all main strings

are installed. Tie off ends of main strings as

per racquet manufacturers recommenda-

tions.

Clamping the First Main String

Secure the tensioned main string using the

remaining ﬁ xed clamp. Repeat the procedure

for all of the remaining main strings and tie off

following the racquet manufacturers recom-

mendations.

Follow the manufacturers recommended

stringing pattern for one or two piece stringing.

This will determine the starting point for the

cross strings. If applicable, tie the ﬁ rst cross

string using an appropriate starting knot.