- ページ 10

ストリング・マシン Gamma PROGRESSION 602のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Gamma PROGRESSION 602 12 ページ。
Gamma PROGRESSION 602 にも：オーナーズマニュアル (16 ページ)

Your GAMMA Progression 602 stringing machine is adjusted for optimum performance at the factory and needs no

further adjustments before use. After extensive use however, the machine may need minor adjusments as follows

Note: The string clamps supplied with your stringing machine can accomodate tight string patterns such as

badminton. Depending on the string pattern, the clamp will spread the strings slightly which will not compromise the

quality of the string job.

MAINTENANCE

Adjusting the Turntable Bushings

There are two adjustment points on the machine base.

One is located beneath the polystyrene base cover while

the other is accessed from below the machine.

Using the supplied 3mm hex wrench, tighten both set

screws slightly until the turntable rotates smoothly with-

out excessive free play.

Repeat procedure until final adjustment is reached.

Adjusting the Clamps

The clamps provided with your stringing machine will

need minor adjustments according to what string type,

construction, and gauge you are using.

To adjust, route the string through the racquet as if you

were beginning the main strings. Clamp the strings and

pull tension. If the string slips through the jaws of the

clamp, tighten the clamp by turning the adjustment knob

Adjustment

opposite of the handle, in the clockwise direction. If the

Knob

clamp leaves impressions or damages the string, it is too

tight and must be adjusted by turning the adjustment

knob counterclockwise.

The clamp jaws must be clean and free from dirt, oil, and

any string coating for them to grip properly. Clean the

clamp jaws with alcohol.