Gamma PROGRESSION 602 Manual do Proprietário - Página 10
Procurar online ou descarregar pdf Manual do Proprietário para Máquinas de encordoar Gamma PROGRESSION 602. Gamma PROGRESSION 602 12 páginas.
Também para Gamma PROGRESSION 602: Manual do Proprietário (16 páginas)
Imprimir página
Your GAMMA Progression 602 stringing machine is adjusted for optimum performance at the factory and needs no
further adjustments before use. After extensive use however, the machine may need minor adjusments as follows
:
Note: The string clamps supplied with your stringing machine can accomodate tight string patterns such as
badminton. Depending on the string pattern, the clamp will spread the strings slightly which will not compromise the
quality of the string job.
MAINTENANCE
Adjusting the Turntable Bushings
There are two adjustment points on the machine base.
One is located beneath the polystyrene base cover while
the other is accessed from below the machine.
Using the supplied 3mm hex wrench, tighten both set
screws slightly until the turntable rotates smoothly with-
out excessive free play.
Repeat procedure until final adjustment is reached.
Adjusting the Clamps
The clamps provided with your stringing machine will
need minor adjustments according to what string type,
construction, and gauge you are using.
To adjust, route the string through the racquet as if you
were beginning the main strings. Clamp the strings and
pull tension. If the string slips through the jaws of the
clamp, tighten the clamp by turning the adjustment knob
Adjustment
opposite of the handle, in the clockwise direction. If the
Knob
clamp leaves impressions or damages the string, it is too
tight and must be adjusted by turning the adjustment
knob counterclockwise.
The clamp jaws must be clean and free from dirt, oil, and
any string coating for them to grip properly. Clean the
clamp jaws with alcohol.
9