- ページ 16

産業機器 Centrometal EKO-CUP V3のPDF テクニカル・インストラクションをオンラインで閲覧またはダウンロードできます。Centrometal EKO-CUP V3 20 ページ。

Burner adjustment and mounting

10.1. BURNER ADJUSTMENT

Burner must be adjusted according to the technical instructions for the oil / gas burner.

10.2.

Burner mounting

is used if the factory made opening on the boiler door is too large for the chosen

burner. In that case it is necessary to make an appropriate opening for the passage of the burner tube

and to cut the existing mineral wool isolation layer according to the mentioned opening. If it is

necessary, make attach holes for the burner.

Figure 4: Burner mounting on the boiler EKO-CUP V3

Boiler door isolation

ATTENTION !!

If the factory made opening on the boiler door is too large for the chosen burner, it is necessary to make

an appropriate opening for burner tube passage on the blind panel. The existing isolation mineral wool

layer have to be cut to be consistent with that opening. For the burner connection use the existing

holes or if it is necessary make new attach holes for the burner. If after the boiler montage, the gap

between the burner tube and the mineral wool isolation of the boiler door still exist, it is necessary to fill

the gap with pieces of the mineral wool and the braid ( which is delivered with the boiler ) so that the gap

becomes closed (Figure 4).

Mineral wool

Isolation panel

Blind panel

Gap which must

be closed

Burner tube

Technical instructions EKO-CUP V3