- ページ 4
ストリング・マシン Gamma X-2のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Gamma X-2 11 ページ。
Gamma X-2 にも： オーナーズマニュアル (16 ページ)
ページを印刷する
ASSEMBLY INSTRUCTIONS
Clamp Adjustment
Thumb Knob
Winder Support Stand Installation
Attach the winder support stand to the ma-
chine base using the 5MM hex key (in-
cluded) by sliding the 2 brackets into the 2
rear most grooves. Then align the right side
of the stand with the right end of the base.
Tension Bar Stop Screw
Raise the Tension Bar to an upright position.
Using the supplied 5MM wrench, securely
tighten the Stop Screw. This will prevent the
Tension bar from contacting the racquet frame.
Clamp Adjustment
The floating clamps provided with your ma-
chine will need minor adjustments according
to what string type, construction, and gauge
you are using.
If the strings slip through the jaws of the
clamp, tighten the clamp by turning the
thumb knob opposite of the handle, in the
clockwise direction. If the clamps leave im-
pressions or damage the string, they are too
tight and the thumbwheel must be turned
counterclockwise.
The clamp jaws must be clean and free from
dirt, oil, and any string coating for them to
grip properly. Keep the clamp jaws clean
with alcohol.
3