Gamma X-2 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Gamma X-2에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma X-2 11 페이지.
Gamma X-2에 대해서도 마찬가지입니다: 소유자 매뉴얼 (16 페이지)

ASSEMBLY INSTRUCTIONS

Clamp Adjustment

Thumb Knob

Winder Support Stand Installation

Attach the winder support stand to the ma-

chine base using the 5MM hex key (in-

cluded) by sliding the 2 brackets into the 2

rear most grooves. Then align the right side

of the stand with the right end of the base.

Tension Bar Stop Screw

Raise the Tension Bar to an upright position.

Using the supplied 5MM wrench, securely

tighten the Stop Screw. This will prevent the

Tension bar from contacting the racquet frame.

Clamp Adjustment

The floating clamps provided with your ma-

chine will need minor adjustments according

to what string type, construction, and gauge

you are using.

If the strings slip through the jaws of the

clamp, tighten the clamp by turning the

thumb knob opposite of the handle, in the

clockwise direction. If the clamps leave im-

pressions or damage the string, they are too

tight and the thumbwheel must be turned

counterclockwise.

The clamp jaws must be clean and free from

dirt, oil, and any string coating for them to

grip properly. Keep the clamp jaws clean

with alcohol.