- ページ 9

バスルーム設備 decina Luna 1000 SB1000C3TのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。decina Luna 1000 SB1000C3T 11 ページ。 Shower bases & acrylic shower wall

ページを印刷する

SHOWER BASE INSTALLATION FOR

TILE WALL APPLICATIONS

For tile wall applications it is important that the bottom edge of the wet area sheet sits in

front of the shower base tile bead - the following steps are required to prepare the wall.

WALL PREPARATION FOR TIMBER STUD WALL FRAMES ON TILE LINING

INSTALLATIONS

Locate the shower base against the timber stud wall and mark the position of

•

the base along the studs and down the shower base sides at a distance of 10mm

greater with a pencil.

With a chisel, check out the timber frame to a depth of between 10-15mm. This allows

•

the shower base tile bead to sit behind the final wet area sheeting for waterproofing.

TRAY INSTALLATION FOR TILE WALL APPLICATIONS

Refer Steps A - G Section 10

Allow the shower base to cure for at least 24 hrs as per the adhesive

•

manufacturer's instructions before installing the wall sheeting. This ensures the

shower base level will not change by standing on it.

Once the shower base bond is fully cured, the wet area sheeting can be applied

•

over the shower base tile bead as per the relevant wet area sheet manufacturer's

instructions. The wet area sheet should sit over the front of the tile bead. Ensure

the wet area sheet is installed at least 6mm above the shower base floor level,

for expansion.

S H OWE R IN STA LLATI O N G U I D E

10mm

High

10–15mm Deep

6mm min

Once sheeting is completed, use a flexible waterproof sealant (not supplied) to

•

seal the gap between the shower base and the wet area sheet.

WALL PREPARATION FOR STEEL STUD WALL FRAMES ON TILE WALL

INSTALLATIONS - SEE BELOW

NOTE: As a steel wall stud should not be cut, it is necessary to build out the wall level to

clear the shower base tile bead thickness. On top of this a thinner 6mm wet area sheet

is installed down inside the tile bead, this will provide support behind the bottom row of

tiles. (See instructions below)

A suitable wet area sheet product of no less than 12mm thickness is required to

•

achieve the desired level. Use of either a 13mm wet area plasterboard or 12mm

wet area fibre cement sheet is advised.

Install the chosen 12 or 13mm wet area sheet

•

product bottom edge at least 6mm above the tile

bead (as per relevant manufacturer's instructions).

Once completed the final 6mm wet area sheet can

•

be installed onto the 12 or 13mm wet area sheet.

Ensure the 6mm wet area sheet is installed at

least 5-6mm above the shower base for expansion.

Once sheeting is completed, use a flexible

•

waterproof sealant (not supplied) to seal the gap

between the shower base and the 6mm wet area sheet.

Refer to Section 13 for Cleaning and Maintenance Instructions

6mm min

SH OW ER I NS TA LLATI O N G UI DE