- ページ 11

DJ機材 Gamma Led Vision Starburst VersaのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Gamma Led Vision Starburst Versa 18 ページ。 18x30w rgbwa+uv (6in1)

DMX Cables can be 3-pin or 5-pin. These use the same type of data, and in the 5-pin only pins

1, 2, and 3 are used. The cable should be a 2 conductor, shielded cable of at least 110 ohms

resistance. Microphone cable is not DMX cable.

Please refer to the diagram below:

For installations where the DMX cable has to run a long distance or is in an electrically noisy

environment, it is recommended to use a DMX terminator. This helps in preventing corruption

of the digital control signal by electrical noise and reflections. The DMX terminator is simply an

XLR plug with a 120 Ω resistor connected between pins 2 and 3, which is then plugged into

the output XLR socket of the last fixture in the chain. Please see illustrations below: