ページを印刷する
1. Carpentry
Refer to figure 1 for the dimensions applicable
to your appliance, and the space necessary to
receive the oven. The oven support surface may
be solid plywood or similar material, however the
surface must be level from side to side and from
front to rear.
2. Adjusting Oven Height
Oven height can be adjusted with 2" (5 cm) wide
wood shims when needed to fit into an existing
cabinet cutout opening, when cutout height
exceeds 28
/
" (71.8 cm) for the single wall oven
1
4
(see Figure 1). Place shims of appropriate height
beneath the oven side rails.
3. Electrical Requirements
Each appliance must be supplied with the proper
voltage and frequency, and connected to an
individual, properly grounded branch circuit,
protected by a circuit breaker or fuse. To know the
circuit breaker or fuse required by your model, see
the rating plate to find the wattage consumption
and refer to Figure 2 to get the circuit breaker or
fuse amperage.
Appliance
Protection
Rating
Circuit
Watts
Recommended
240V
Less than
20A
4800W
4801W -
30A
7200W
7201W -
40A or 50A
9600W
9601W and
50A
+
Observe all governing codes and local ordinances.
1. A 3-wire or 4-wire single phase 120/240 or
120/208 Volt, 60 Hz AC only electrical supply
is required on a separate circuit fused on both
sides of the line (red and black wires). A time-
delay fuse or circuit breaker is recommended.
DO NOT fuse neutral (white wire). Only
certain cooktop models may be installed over
certain built-in electric oven models. Approved
cooktops and built-in ovens are listed by
the MFG ID number (see the insert sheet
included in the literature package). Do not
install a cooktop over a side-by-side wall oven
installation.
6
Appliance
Protection
Rating Watts
Circuit
208V
Recommended
Less than
4100W
4101W -
6200W
6201W -
40A or 50A
8300W
8301W and +
Figure 2
NOTE: Wire sizes and connections must conform
with the fuse size and rating of the appliance in
accordance with the American National Electrical
Code ANSI/NFPA No. 70-latest edition, or with
Canadian CSA Standard C22.1, Canadian Electrical
Code, Part 1, and local codes and ordinances.
An extension cord should not be used with
this appliance. Such use may result in a fire,
electrical shock, or other personal injury. If you
need a longer power cord you can purchase
a 10' (3 m) power cord kit #903056-9010 by
calling the Service Center.
2. These appliances should be connected to
the fused disconnect (or circuit breaker)
box through flexible armored or nonmetallic
sheathed cable. The flexible armored cable
extending from the appliance should be
connected directly to the junction box. The
junction box should be located as shown in
Figure 1 and with as much slack as possible
remaining in the cable between the box and
the appliance, so it can be moved if servicing is
ever necessary.
3. A suitable strain relief must be provided
to attach the flexible armored cable to the
junction box.
20A
30A
50A
WARNING!
AA-2194876-2