IKEA ADRATT Manual de instalação - Página 6

Procurar online ou descarregar pdf Manual de instalação para Forno IKEA ADRATT. IKEA ADRATT 37 páginas.

Imprimir página

1. Carpentry

Refer to figure 1 for the dimensions applicable

to your appliance, and the space necessary to

receive the oven. The oven support surface may

be solid plywood or similar material, however the

surface must be level from side to side and from

front to rear.

2. Adjusting Oven Height

Oven height can be adjusted with 2" (5 cm) wide

wood shims when needed to fit into an existing

cabinet cutout opening, when cutout height

exceeds 28

" (71.8 cm) for the single wall oven

(see Figure 1). Place shims of appropriate height

beneath the oven side rails.

3. Electrical Requirements

Each appliance must be supplied with the proper

voltage and frequency, and connected to an

individual, properly grounded branch circuit,

protected by a circuit breaker or fuse. To know the

circuit breaker or fuse required by your model, see

the rating plate to find the wattage consumption

and refer to Figure 2 to get the circuit breaker or

fuse amperage.

Appliance

Protection

Rating

Circuit

Watts

Recommended

240V

Less than

20A

4800W

4801W -

30A

7200W

7201W -

40A or 50A

9600W

9601W and

50A

Observe all governing codes and local ordinances.

1. A 3-wire or 4-wire single phase 120/240 or

120/208 Volt, 60 Hz AC only electrical supply

is required on a separate circuit fused on both

sides of the line (red and black wires). A time-

delay fuse or circuit breaker is recommended.

DO NOT fuse neutral (white wire). Only

certain cooktop models may be installed over

certain built-in electric oven models. Approved

cooktops and built-in ovens are listed by

the MFG ID number (see the insert sheet

included in the literature package). Do not

install a cooktop over a side-by-side wall oven

installation.

Appliance

Protection

Rating Watts

Circuit

208V

Recommended

Less than

4100W

4101W -

6200W

6201W -

40A or 50A

8300W

8301W and +

Figure 2

NOTE: Wire sizes and connections must conform

with the fuse size and rating of the appliance in

accordance with the American National Electrical

Code ANSI/NFPA No. 70-latest edition, or with

Canadian CSA Standard C22.1, Canadian Electrical

Code, Part 1, and local codes and ordinances.

An extension cord should not be used with

this appliance. Such use may result in a fire,

electrical shock, or other personal injury. If you

need a longer power cord you can purchase

a 10' (3 m) power cord kit #903056-9010 by

calling the Service Center.

2. These appliances should be connected to

the fused disconnect (or circuit breaker)

box through flexible armored or nonmetallic

sheathed cable. The flexible armored cable

extending from the appliance should be

connected directly to the junction box. The

junction box should be located as shown in

Figure 1 and with as much slack as possible

remaining in the cable between the box and

the appliance, so it can be moved if servicing is

ever necessary.

3. A suitable strain relief must be provided

to attach the flexible armored cable to the

junction box.

20A

30A

50A

WARNING!

AA-2194876-2