- ページ 8
インターホン・システム Centurion POLOphoneのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Centurion POLOphone 17 ページ。 Entry panel
Centurion POLOphone にも： インストレーション・マニュアル (16 ページ), インストレーション・マニュアル (17 ページ), 委託手続き (4 ページ)
ページを印刷する
Entry panel installation
1A
Wall Mount Installation
Position entry panel on wall
adjacent to entrance gate or
door
Mount at a height that allows
for comfortably speaking into
the microphone
A recommended height is
shown
3
Lift off the outer cover of the
entry panel
6
In the case of an uneven wall,
the tabs may be cut as shown
to allow the base to 'sit' on the
wall without rocking
Page 8 - POLOphone Intercom
1B
Gooseneck Installation
Alternatively mount the entry panel
onto a gooseneck ensuring that:
The entry panel does not
protrude too far into the
driveway
The entry panel is not set too
far back and can be easily
accessed from a vehicle
The height allows for
comfortably speaking into the
microphone
4
Insert screwdriver as shown
and unclip the electronic
module from base
7
100mm
Hold the entry panel base against
the wall at the required height
ensuring that it is vertical.
Mark the location of the mounting
holes.
2
Dimensions of the entry panel
base and mounting holes
relative to the entry panel
cover
5
Lift electronic module off base
Using a 6mm masonry bit, drill
holes into the wall for the rawlplugs
provided in the kit.
If the cable is being routed into the
unit from a concealed conduit behind
A
the base, knock out one of the cable
entry holes provided in the base and
feed through the cable. Ensure that at
least 100mm of cable extends out of
the wall.
Fit sealing washer (A) onto top
mounting screw before installing.
Screw the base firmly into position
and using the slots provided in the
mounting holes, adjust the base to be
perfectly vertical.
(B) Ensure that sealing washer is
fitted and closes off the mounting hole
to prevent water ingress.
74mm