- ページ 6

オーブン IKEA NUTIDのPDF 設置および使用説明書をオンラインで閲覧またはダウンロードできます。IKEA NUTID 46 ページ。 French door refrigerator
IKEA NUTID にも: インストレーション・マニュアル (16 ページ), インストレーション・マニュアル (12 ページ), 組立説明書 (12 ページ)

IKEA NUTID 設置および使用説明書
Connect to Refrigerator
Depending on your model, the water line may come down
from the top or up from the bottom. Follow the connection
instructions for your model.
Style 1
1. Remove plastic cap from water valve inlet port. Attach the
copper tube to the valve inlet using a compression nut
and sleeve as shown. Tighten the compression nut. Do not
overtighten. Confirm copper tubing is secure by pulling on
copper tubing.
2. Create a service loop with the copper tubing. Avoid kinks
when coiling the copper tubing. Secure copper tubing to
refrigerator cabinet with a "P" clamp.
A
B
C
D
A. Copper tubing
B. "P" clamp
3. Turn on water supply to refrigerator and check for leaks
Correct any leaks.
Style 2
1. Create a service loop (minimum diameter of 2 ft [61 cm])
with the copper tubing. Avoid kinks when coiling the copper
tubing.
2. Remove the plastic cap from water valve inlet port. Place a
compression nut and sleeve on the copper tubing.
3. Insert the end of the copper tubing into the water valve inlet
port. Shape tubing slightly so that the tubing feeds straight
into the port to avoid kinks.
4. Slide the compression nut over the sleeve and screw into
the water valve inlet port.
A. Plastic water tubing
B. Sleeve
6
C.Compression nut
D.Compression sleeve
A
B
C
D
C.Compression nut
D.Copper tubing
5. Using an adjustable wrench, hold the nut on the plastic
water line to keep it from moving. Then, with a second
wrench turn the compression nut on the copper tubing
counterclockwise to completely tighten. Do not overtighten.
A. "P" clamp
B. Plastic water line
6. Check connection by pulling on copper tubing. Attach
the plastic water line to the refrigerator cabinet with a "P"
clamp.
7. Turn on water supply to the refrigerator and check for leaks
Correct any leaks.
Complete the Installation
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
NOTE: Allow 24 hours to produce the first batch of ice.
Discard the first three batches of ice produced. Allow 3 days to
completely fill the ice storage bin.
A
B
C
D
C.Compression nut
D.Copper tubing