- ページ 6

農機具 Green Frog Designs Chicken LodgeのPDF 組み立て方をオンラインで閲覧またはダウンロードできます。Green Frog Designs Chicken Lodge 9 ページ。 Small

Fit two Vent Covers to the patterned face of the Right

Side Wall each using an M6x30mm screw, a standard

washer, a 25mm washer and a nylock nut.. Tighten the

nuts until the vents can rotate using gentle pressure.

They should not spin freely.

The Left Side Wall has vent slots, to ensure the chickens

have some fresh air at all times.

Fit the Small Clevis Pin into the hole in the Metal Door

from behind, and secure it using a washer and split ring.

This can be a little awkward. We find that holding the split

ring open by inserting a flat-bladed screwdriver between

the rings can make this task easier. But please mind your

fingers!

Fit both Side Walls to the Base using Pi Clips. Ensure that

the Double-hole lugs are at the front. Then fit the Roof

Support and the Lower Back Wall between the two side

walls using Pi Clips.

NOTE: The Base may be fitted either way up (we

recommend patterned side upwards).

Printed on recycled paper

HOW TO ASSEMBLE

Fit the Small and Large Curved Door Retainer, and the

Small and Large Straight Door Retainer to the smooth

(inside) side of the Front Wall using 30mm and 40mm

Screws, Standard Washers, and Nylock Nuts.

These pieces form a recess into which the door fits when

closed, to make the door resistant to fox attack.

Place the Metal Door in position, and secure it with a

20mm screw, two Standard Washers, a 25mm Washer

and a Nylock Nut. Tighten the Nylock Nut until the door

can just rotate freely.

Fit the Front Wall (patterned face outermost) to the end

with the double-hole lugs using Pi Clips.

NOTE: If you have purchased a Leg Set, the Front Leg

Extensions should be fitted at this stage. If you have

purchased a Wheel Set, the Wheel Bar should be

assembled and fitted at this stage.

Page 6 of 9