- ページ 8

農機具 Green Frog Designs Chicken LodgeのPDF 組み立て方をオンラインで閲覧またはダウンロードできます。Green Frog Designs Chicken Lodge 9 ページ。 Small

Fit the Nestbox Front Brace and the two Nestbox Side

Braces to the Nestbox Lid, which should have its

patterned side upwards, using Pi Clips.

Fit the Ramp under the door using the two Long Clevis

Pins and R-Clips. It will tilt to the ground under its own

weight.

MANUAL DOOR ONLY: Tie one end of the Cord to the

Split Ring in the Front Door and the other to the small

hole in the Door Handle. The Cord should pass through

the handle slot. Adjust the length of the cord so that,

when the door is fully raised, the handle just hooks onto

the edge of the opposite handhold or the roof edge.

Printed on recycled paper

The Nest Box Lid simply slides upwards so that the

cutouts fit into the recesses in the vertical panels. It is

secured with Linch Pins which can be tied to the End

Braces using 30cm of cord for each.

Fit the Roof using Linch Pins (Fix the centre first, then

bend it over the remaining lugs).

AUTOMATIC OPENER ONLY: Use four 3mm Screws,

Washers, and Nylock Nuts to secure the Chickenguard

automatic door opener to the holes provided.

Instructions for setting it up are provided with the opener

itself.

Page 8 of 9