- ページ 17

冷蔵庫 IKEA NUTIDのPDF 設置および使用説明書をオンラインで閲覧またはダウンロードできます。IKEA NUTID 46 ページ。 French door refrigerator
IKEA NUTID にも：インストレーション・マニュアル (16 ページ), インストレーション・マニュアル (12 ページ), 組立説明書 (12 ページ)

ページを印刷する

The refrigerator seems noisy

Refrigerator noise has been reduced over the years. Due to

this reduction, you may hear intermittent noises from your new

refrigerator that you did not notice from your old model. Below

are listed some normal sounds with explanations.

Buzzing - heard when the water valve opens to fill the ice

■

maker

Pulsating - fans/compressor adjusting to optimize

■

performance

Hissing/Rattling - flow of refrigerant, movement of water

■

lines, or from items placed on top of the refrigerator

Sizzling/Gurgling - water dripping on the heater

■

duringdefrost cycle

Popping - contraction/expansion of inside walls, especially

■

during initial cool-down

Water running - may be heard when ice melts during the

■

defrost cycle and water runs into the drain pan

Creaking/Cracking - occurs as ice is being ejected from

■

the ice maker mold.

The doors will not close completely

Door blocked open? Move food packages away from door.

■

Bin or shelf in the way? Push bin or shelf back in the

■

correct position.

The doors are difficult to open

WARNING

Explosion Hazard

Use nonflammable cleaner.

Failure to do so can result in death, explosion, or fire.

Gaskets dirty or sticky? Clean gaskets and contact

■

surfaces with mild soap and warm water. Rinse and dry with

soft cloth.

Temperature and Moisture

Temperature is too warm

New installation? Allow 24 hours following installation for

■

therefrigerator to cool completely.

Door(s) opened often or left open? Allows warm air to

■

enter refrigerator. Minimize door openings and keep doors

fully closed.

Large load of food added? Allow several hours for

■

refrigerator to return to normal temperature.

Controls set correctly for the surrounding conditions?

■

Adjust the controls a setting colder. Check temperature in

24 hours. See "Using the Control(s)."

There is interior moisture buildup

NOTE: Some moisture buildup is normal.

Humid room? Contributes to moisture buildup.

■

Door(s) opened often or left open? Allows humid air to

■

enter refrigerator. Minimize door openings and keep doors

fully closed.

Ice and Water

The ice maker is not producing ice or not enough ice

Refrigerator connected to a water supply and the supply

■

shutoff valve turned on? Connect refrigerator to water

supply and turn water shutoff valve fully open.

Kink in the water source line? A kink in the line can

■

reduce water flow. Straighten the water source line.

Ice maker turned on? Make sure wire shutoff arm or

■

switch (depending on model) is in the ON position.

New installation? Wait 24 hours after ice maker installation

■

for ice production to begin. Wait 72 hours for full ice

production.

Freezer door closed completely? Firmly close the freezer

■

compartment door. If the freezer compartment door will not

close all the way, see "The doors will not close completely,"

earlier in this section.

Large amount of ice recently removed? Allow 24 hours

■

for ice maker to produce more ice.

Ice cube jammed in the ice maker ejector arm? Remove

■

ice from the ejector arm with a plastic utensil.

Water filter installed on the refrigerator? Remove filter

■

and operate ice maker. If ice volume improves, then the

filter may be clogged or incorrectly installed. Replace filter

or reinstall it correctly.

Reverse osmosis water filtration system connected

■

to your cold water supply? This can decrease water

pressure. See "Water Supply Requirements."

The ice cubes are hollow or small

NOTE: This is an indication of low water pressure.

Water shutoff valve not fully open? Turn the water shutoff

■

valve fully open.

Kink in the water source line? A kink in the line can

■

reduce water flow. Straighten the water source line.

Water filter installed on the refrigerator? Remove filter

■

and operate ice maker. If ice quality improves, then the filter

may be clogged or incorrectly installed. Replace filter or

reinstall it correctly.

Reverse osmosis water filtration system connected

■

to your cold water supply? This can decrease water

pressure. See "Water Supply Requirements."

Questions remain regarding water pressure? Call a

■

licensed, qualified plumber.

Off-taste, odor or gray color in the ice

New plumbing connections? New plumbing connections

■

can cause discolored or off-flavored ice.

Ice stored too long? Discard ice. Wash ice bin. Allow 24

■

hours for ice maker to make new ice.

Odor transfer from food? Use airtight, moisture proof

■

packaging to store food.

Are there minerals (such as sulfur) in the water? A water

■

filter may need to be installed to remove the minerals.

Water filter installed on the refrigerator? Gray or dark

■

discoloration in ice indicates that the water filtration system

needs additional flushing. Flush the water system before

using a new water filter. Replace water filter when indicated.

See "Water Filtration System."