- ページ 13

車椅子 decon AdventusのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。decon Adventus 18 ページ。 Folding wheelchair adaptor
decon Adventus にも：組み立て説明書 (8 ページ)

2. Fold up the locking lever (A) to open the front

attachment (C).

3. Loosen the screw (K) on the underside of the

frame.

Loosen the locking screws (L) and move the

front attachment (C) as far back as possible.

4. Loosen the locking screws (M) and move the

rear attachment (B) as far back as possible.

5. Loosen screws (N) and the adjustment screw

(O) so that the screws (N) kan move freely

inside the track for angle adjustment (E).

6. Put the wheel in its front position, put

Adventus in place on the footrest by inserting

the attachment (B) so that it locks into the

rear tube of the footrest.

Lower the wheel to the ground level and lock

the front tube of the footrest by folding down

the locking lever (A).

Tighten the screw (K) until the front

attachment (C) locks against the footrest.

Tighten the locking screws (L).

7. Press the rear attachment (B) back with your

hand so that it locks against the rear tube of

the footrest.

Tighten the locking screws (M).

8. Adjust the adjustment screw (O) until the

wheelchair´s front castors are just lifted from

the ground. Tighten the screws (N) on both

sides.

9. Turn the wheel to its rear position and check

that the front castors lift from the ground.

Recomended height is 30-40mm.

If the front castors are not lifted enough from

the ground then, if possible, move the wheel

to a higher position in the fork. If the wheel

position is changed the adjustment screw (O)

and screws (N) must be loosened again to

remake the adjustment from item 8.

Mechanical settings

Sida 13/18

Adventus

User manual