- ページ 6

おもちゃ Bernard Burton Spirit of PittsのPDF 組立マニュアルをオンラインで閲覧またはダウンロードできます。Bernard Burton Spirit of Pitts 11 ページ。

Step 10: Prepare the landing gear cover:

Glue the F1a formers together via 10x10 mm and 5x5 mm sticks

Cover with 2 mm balsa sheet.

The landing gear cover must fit in the fuse landing gear hole but should not be glued

on the fuse

Cut the landing gear cover at the level of the fuse landing gear exit.

Step 11: Cover the fuse:

Prepare the covering sheets by gluing the required number of 2 mm balsa sheet and

required length side by side. This operation can easily be done with CA glue when the

sheets are placed on a Wax paper.

To allow easy sheet wrapping around the fuse, you can spread an Ammoniac-Water

mixture on the balsa sheet. Wrap the wet sheet in place and let it dry for a night

Use CA glue to glue the balsa sheets according the plan drawings with special care

for the wing join.

Step 12: Elevator and rudder assembly:

On a flat workbench, build the elevator and rudder panels using a copy of the plans.

Use polyurethane glue for maximal robustness.

Use 10x10 mm hard wood for the leading edge of the fix rudder and elevator parts.

Glue the rudder (fixed part) on the elevator (fixed part) at 90° with 30' epoxy. Re-

enforce the glue join with triangle spars.

We recommend using 3mm Pin-hinges for the rudder and elevator articulations.

Check the fit on the fuse but do not glue on the fuse at this stage.

DRAFT