- ページ 3

IPカメラ Ganz ZN-DNT352XE-MIRのPDF クイック・ユーザー・マニュアルをオンラインで閲覧またはダウンロードできます。Ganz ZN-DNT352XE-MIR 8 ページ。

Step3. Set the lens position

1) Remove the dome cover.

2) Set the lens position by rotating the camera gimbal; to pan, rotate the reinforced lower body of the

gimbal; to tilt, vertically adjust the camera gimbal.

A. To adjust lens position,

rotate the camera gimbal

Refrain from continuously rotating the camera gimbal with excessive force to a single direction

as it is attached with the IR‐LED cable inside the dome.

Caution

3) The figure and table below explains the lens switch settings.

NC3502 Ver1.3

B. To pan, rotate the lower

body of the camera gimbal

SW1

PAL/NTSC

SW4

FAR

C. Tilt the lens by vertically

adjusting the camera gimbal

SW2

SW3

TELE

WIDE

SW5

SW6

Auto‐

NEAR

Focus