- ページ 2
エンジン GAPOSA XQ50のPDF プログラミング・クイック・マニュアルをオンラインで閲覧またはダウンロードできます。GAPOSA XQ50 7 ページ。 Tubular motors with mechanical limit switch and integrated receiver.
GAPOSA XQ50 にも： 取扱説明書 (8 ページ), 使用方法 (4 ページ), マニュアル (15 ページ), 取扱説明書 (13 ページ), マニュアル (13 ページ), マニュアル (16 ページ), 取扱説明書 (8 ページ)
ページを印刷する
1
2
3
4
5
AUTOMATIC LIMIT SETTING
1. CONNECT POWER TO THE MOTOR
2. PAIRING THE REMOTE
1
Press and hold Prog-TX (4)
on the back of the remote till
the motors starts running
3. CHANGING DIRECTION
1
Press and hold Prog-TX (4)
on the back of the remote till
the motors starts running
4. SETTING THE LIMITS (Always set TOP limit first)
1
Press and hold the Prog-FC (5)
button on the back of the remote
till the motor makes a brief jog
1
UP
Rolling shutter up
STOP
2
Rolling shutter stops
3
DOWN
Rolling shutter down
PROG-TX
4
Pairing remote
5
PROG-FC
Set limits
2
Check the motor rotational direction then
release Prog-TX (4). Motor stops
- Press UP button on the front and hold it for more than 2 sec:
- The motor runs upward to the TOP limit, it stops itself (because of
the mechanical top stops) and sets the TOP limit.
- After few seconds it starts running automatically downwards to
set the BOTTOM limit.
- When the roller shutter is completely closed the motor stops
setting the BOTTOM limit
3
Within 5 seconds, press the corresponding button:
- UP if the motor turns upwards
- DOWN if the motor turns downwards
Remote is now paired
2
Release Prog-TX (4) then press STOP.
The motor makes a brief jog.
Direction of the motor has been reversed
IMPORTANT: the change of direction of
operation must be performed BEFORE
1
initiating limit setting procedure
otherwise limits must be reset
2
To confirm make a
full TOP/BOTTOM operation
of the shutter