- ページ 4
エンジン GAPOSA XQ50のPDF プログラミング・クイック・マニュアルをオンラインで閲覧またはダウンロードできます。GAPOSA XQ50 7 ページ。 Tubular motors with mechanical limit switch and integrated receiver.
GAPOSA XQ50 にも： 取扱説明書 (8 ページ), 使用方法 (4 ページ), マニュアル (15 ページ), 取扱説明書 (13 ページ), マニュアル (13 ページ), マニュアル (16 ページ), 取扱説明書 (8 ページ)
ページを印刷する
PREFERRED POSITION
1. SETTING THE
INTERMEDIATE POSITION
1
2
Move the motor and
stop it at the desired
intermediate position
DELETING A TRANSMITTER OR A CHANNEL
RESET TRANSMITTER MEMORY
Option 1 - Using a programmed transmitter
Press and hold both PROG-TX and STOP buttons for at least
15 seconds: as confirmation feedbacks the motor makes first a
brief jog and after 5 seconds an additional jog
Memory is now empty
Press both UP and DOWN
buttons together till the motor
makes a brief jog
The intermediate position is set
2. RECALLING THE
INTERMEDIATE POSITION
3"
Press and hold the STOP button for
3 seconds: the motor will move and
stop at the intermediate position
Using the transmitter to be deleted press and hold both PROG-TX and STOP
buttons till the motor makes a brief jog
Only the transmitter used for this procedure has been deleted from
motor memory
(DELETING ALL THE TRANSMITTERS OR CHANNELS OR SENSORS)
1
Option 2 - Using a new transmitter without ID (not paired).
1 Switch the motor power supply OFF. Then switch it ON.
2 Within 8 seconds, using any Gaposa transmitter, press and hold both
PROG-TX and STOP buttons until the motor makes a jog
Memory is now empty
3. ERASING THE
INTERMEDIATE POSITION
Press both UP and DOWN buttons till
the motor makes a brief jog.
The intermediate position has been
erased
2
GAPOSA Inc.
GAPOSA srl
3920 Providence Road
via Ete, 90 - 63900 Fermo - Italy
Newtown Square PA 19073
T. +39.0734.22071 - F. +39.0734.226389
Ph. 484 885 0540
[email protected] - www.gaposa.com