- ページ 5

室内装飾品 BERNHARDT design a.k.a. C-baseのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。BERNHARDT design a.k.a. C-base 20 ページ。

Step 11

To install the next Workwall Structure section, simply lift

into place and slip the yellow alignment pins into

corresponding rail of the previous mounted section. Make

sure that the seam between the two sections is tight

without gaps.

Repeat Steps 7-11 for the remaining Workwall Structure

sections.

Step 12

After all Workwall Structure sections have been mounted,

they then must be shimmed to be made flat and true

across all of the mounted panels.

Step 13

Place a level or long straight edge along the front surface

of each of the Workwall rails to show the dips or

protruding areas.

Warning: If the panel assembly is not flat and free of any

dips or bulges there may be issues in securing panels or

hanging components properly.

Step 14

The ¼"– 20 bolts use to attached the Workwall sections

can be loosened and a shim can be added between the

wall and the Workwall section to bring out any low spots.

September 2012