- ページ 13

コントロールユニット GAPOSA QC101のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。GAPOSA QC101 16 ページ。 Single-phase control unit

EMERGENCY MODE WITH

FAULTY BAR

This mode allows the movement of the motor with dead-man control also

in case the optoelectronic bar is active or faulty.

Mode description:

• The mode becomes operational after about 30 seconds from the coast

activation (the count is reset if the bar returns to visibility)

• The mode allows the movement of the motor in opening and closing in

dead-man mode regardless of the position of the dip 2.

• The movement of the motor during this mode is automatically stopped

after 5 seconds. The movement can be resumed by pressing the

command again.

Mode activation:

1. Put dip 6 in ON

2. Move dip 3 at least 3 times from ON to OFF (between two OFF-ON

consecutive steps shall not be more than 2 seconds or the movements

count is reset)

3. If the change is activated, the red and green LEDs will flash quickly for

about 4 seconds

4. Put dip 6 back in OFF

Once the mode activated, it will be actually present only in case dip 3 and

4 are in ON (safety active also in opening and optoelectronic bar active).

Otherwise, the mode is not operational even if enabled.

Mode disabling:

The mode can be disabled exclusively by the reset procedure (see

procedure).