- ページ 2

ウィンドウ・ブラインド GAPOSA XQ5のPDF プログラミング・クイック・マニュアルをオンラインで閲覧またはダウンロードできます。GAPOSA XQ5 3 ページ。

ページを印刷する

SETTING THE LIMITS

IT IS MANDATORY TO SET THE "UP" LIMIT

FIRST EVERY TIME

Run the motor to an intermediate position inbetween the two

desired limits. The motor needs to move in the direction of the

limit in order for the limit to be properly set.

1 Press and hold the LIMIT button on the back of transmitter until

the motor makes a brief jog

Note: during "limit setting mode" the operations are in

"deadman control" (The UP and DoWN buttons must be held

down inorder for the motor to move.)

2 Press and hold the UP button and run the motor to the desired

UP limit position.

3 Press the SToP button to set the UP limit position. The motor

makes a brief jog to confirm.

4 Press and hold the DoWN button and run the motor to the

desired DoWN limit position

5 Press the SToP button to set the DoWN limit position.

The motor makes a brief jog to confirm.

Note: Accurate limit setting can be performed by pressing the

LIMIT button a second time: the motor will then will reduce

its output speed, moving slowly in steps towards the desired

limit. Always press the SToP button to set the limit position.

SETTING THE LIMITS INDIVIDUALLY

If the limits need to be changed after the initial limit setting

procedure, it is possible to change the limit positions individually.

One limit can be set without the other limit needing to be set. The

motor can be in any postion to initiate the procedure.

TO CHANGE THE UP LIMIT:

1 From any point between the existing limits, press and hold both

the LIMIT button and the UP button until the motor makes a brief

jog.

Note: during "limit setting mode" the operations are in

"deadman control" (The UP and DoWN buttons must be held

down inorder for the motor to move.)

2 Press and hold the UP button until the desired new UP limit is

reached.

3 Press the SToP button to set the limit. The motor makes a brief jog

to confirm. The new UP limit is set.

TO CHANGE THE DoWN LIMIT:

1 From any point between the existing limits, press and hold both

the LIMIT button and the DoWN button until the motor makes a

brief jog.

Note: during "limit setting mode" the operations are in

"deadman control" (The UP and DoWN buttons must be held

down inorder for the motor to move.)

2 Press and hold the DoWN button until the desired new DoWN

limit is reached

3 Press the SToP button to set the limit. The motor makes a brief

jog to confirm. The new DoWN limit is set.

(Sec. 4)

(Sec. 5)