- ページ 9

室内装飾品 Garage Tek GT1006EのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Garage Tek GT1006E 9 ページ。 Tall cabinet, resin - wall mount

STEP #12: PUSH THE CABINET AGAINST THE PROTUDING BOLTS AND FIRMLY TAP THE BACK OF THE CABINET

AT THE BOLT LOCATIONS. A "WHITE" STRESS MARK WILL APPEAR ON THE CABINET BACK INSIDE SURFACE.

STEP #13: USE A 5/8" TO 1" SPADE DRILL AND DRILL 2 HOLES WHERE THE STRESS MARK(S) APPEARS. PUSH

THE CABINET TO THE WALL SO THE BOLTS ARE INSIDE THE CABINET. INSTALL THE WASHER AND WING NUTS

AND TIGHTEN.

THE WALL BRACKETS DO NOT CARRY ANY LOAD. THEY ARE USED AS A SAFETY

MEASURE TO INSURE THE CABINET IS NOT ACCIDENTLY PULLED FORWARD.

DO NOT DRILL A HOLE SMALLER THAN 5/8" DISMETER. AS THE CABINET IS LOADED,

IT WILL "SETTLE" SLIGHTLY. IF A SMALLER HOLE IS USED, THE BACK WALL WILL PULL

ON THE BOLT AND THE SEPARATE AT THE CABINET SEAMS.

STEP #14

STEP #14: ON BOTH WALL BRACKETS, INSTALL THE WASHER AND WING NUTS AND TIGHTEN.

STEP #15: CHECK IF THE DOOR(S) NEED ANY FURTHER ADJUSTMENT AS SHOWN PREVIOUSLY IN STEP #6.

THE INSTALLATION IS COMPLETE.

PG 9

TALL CABINET, RESIN

QUESTIONS ???? CALL 1-866 664 2724

WALL MOUNT

ASSEMBLY INSTRUCTIONS

STEP # 13

STEP #15

REV 1, 10/11