Garage Tek GT1006E Instrukcja instalacji - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Wyposażenie wnętrz Garage Tek GT1006E. Garage Tek GT1006E 9 stron. Tall cabinet, resin - wall mount
Drukuj stronęSTEP #12: PUSH THE CABINET AGAINST THE PROTUDING BOLTS AND FIRMLY TAP THE BACK OF THE CABINET
AT THE BOLT LOCATIONS. A "WHITE" STRESS MARK WILL APPEAR ON THE CABINET BACK INSIDE SURFACE.
STEP #13: USE A 5/8" TO 1" SPADE DRILL AND DRILL 2 HOLES WHERE THE STRESS MARK(S) APPEARS. PUSH
THE CABINET TO THE WALL SO THE BOLTS ARE INSIDE THE CABINET. INSTALL THE WASHER AND WING NUTS
AND TIGHTEN.
THE WALL BRACKETS DO NOT CARRY ANY LOAD. THEY ARE USED AS A SAFETY
MEASURE TO INSURE THE CABINET IS NOT ACCIDENTLY PULLED FORWARD.
DO NOT DRILL A HOLE SMALLER THAN 5/8" DISMETER. AS THE CABINET IS LOADED,
IT WILL "SETTLE" SLIGHTLY. IF A SMALLER HOLE IS USED, THE BACK WALL WILL PULL
ON THE BOLT AND THE SEPARATE AT THE CABINET SEAMS.
STEP #14
STEP #14: ON BOTH WALL BRACKETS, INSTALL THE WASHER AND WING NUTS AND TIGHTEN.
STEP #15: CHECK IF THE DOOR(S) NEED ANY FURTHER ADJUSTMENT AS SHOWN PREVIOUSLY IN STEP #6.
THE INSTALLATION IS COMPLETE.
PG 9
TALL CABINET, RESIN
QUESTIONS ???? CALL 1-866 664 2724
WALL MOUNT
ASSEMBLY INSTRUCTIONS
STEP # 13
STEP #15
REV 1, 10/11