- ページ 4

ネットワーク・ハードウェア CORNING Eclipse 02UのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。CORNING Eclipse 02U 5 ページ。 Coupler shelf

Page 4

Identification Label

9.1

A label is provided to identify transmitter inputs

(Tx), node outputs, power levels (insertion loss), and

miscellaneous descriptions associated with each I/O

port (Figure 6).

9.2

To access the label card, pull up at the tab in the

center of the shelf. The card may be pulled completely

out of the unit to write information on the label

(Figure 6).

9.3

The "Loss (dB)" information is always included

and represents the measured insertion loss of each

port. All other information can be added as required.

SRP-009-222

Connectors are extremely delicate devices. Therefore

the following precautions should always be observed.

• At installation, use a clean tissue soaked in isopropyl

alcohol to gently clean the connectors at the end

of the jumper or pigtail. Clean all the areas of the

connector that will contact the connector sleeve.

• Do not press on connectors as you clean. Doing so

may scratch or crack the connector surface, making

it unusable.

• Carefully press the connector into its receptacle and

tighten. Do not overtighten. Doing so can damage

the connector surface.

• Do not allow the connector body (ferrule) to turn

as you screw it into place. Doing so will allow

the surfaces to grind against each other causing

scratches on the connector surface.

• The connector should fit into its receptacle easily. If

it binds, back it up. Do not force.

• Clean external components of installed connectors

at regular intervals as recommended by their

manufacturer.

Issue 3

KPA-2553

Figure 6