ミシンアクセサリー Bernina Medium Clamp Embroidery HoopのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Bernina Medium Clamp Embroidery Hoop 2 ページ。
![Bernina Medium Clamp Embroidery Hoop クイック・スタート・マニュアル](/uploads/products/server2/2091889/2091889.png)
1
A
B
C
D
E
2
3
BERNINA International AG | CH-8266 Steckborn Switzerland | www.bernina.com | © Copyright by BERNINA International AG
1066905.00A.04
2022-03 EN
Medium Clamp Embroidery Hoop
Information
Scope of delivery
• 1× Embroidery Hoop
• 1× Embroidery Template
• 12× Clamp
Purpose
• To quilt in the hoop.
For your safety
Before using this accessory, please read this instruction manual as well as the
instruction manual of your machine carefully.
Overview
A Clamps
B Hoop
C Embroidery Template
D Push button
E
Application
Hooping the fabric
> Mark the center of the quilt block on the quilt sandwich with a water-
soluble pen.
> Place the quilt sandwich on the hoop.
> Place the Embroidery Template on the quilt sandwich. Make sure that the
quilt sandwich does not get distorted.
> Align the marked center with the center of the Embroidery Template.
(Fig. 2)
> Press the Embroidery Template firmly onto the quilt sandwich.
> Position the first clamp centrally on one side of the hoop. Place second
clamp centrally on the opposite side. Position the third and fourth clamp
centrally on the other two sides. Place the remaining clamps on all sides to
the right and left of the center clamps. (Fig. 3)
> Remove the Embroidery Template from the Embroidery Hoop.
• Embroidery field 8-Series (#26): 8,5 × 8,5" (215 × 215 mm)
• Embroidery field 7-Series (#26): 8,25 × 8,5" (210 × 215 mm) -
limited embroidery field on the left side
• Embroidery field 8- and 7-Series (#43/44C): 8 × 8" (200 × 200 mm)
Embroidery Hoop Connector