- ページ 8

ガレージドアオープナー GarageAce R5のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。GarageAce R5 20 ページ。 Roller garage door opener

8. The Release Handle & Cord

•

Thread one end of the rope through the hole in the

top of the red release handle so that "NOTICE"

reads right side up as shown.

•

Secure with an overhand knot at least 25 mm from

the end of the rope to prevent slipping.

•

Thread the other end of the rope through the loop

of the manual release cable.

•

Adjust rope length so the handle (when installed)

will be no higher than 1.8 m above the floor.

Secure with an overhand knot.

NOTE: Final adjustment of handle height should be

completed after the opener is installed. If it is

necessary to cut the rope, heat seal the cut end to prevent

unravelling.

To disengage the opener

Pull the release cord down firmly;

To re-engage the opener

Pull the release cord down firmly;

NOTE: Disable all locks and remove any ropes connected to

the garage door. Take care when operating the manual

release as an open door may fall rapidly due to weak or

broken springs, or being out of balance.