計測機器 CORNING ONE OIUのPDF クイック・インストール・シートをオンラインで閲覧またはダウンロードできます。CORNING ONE OIU 8 ページ。 Optical interface unit

This document describes the installation and connection procedures for the Corning® optical network evolution (ONE™)

solutions optical interface unit (OIU) and relevant modules.

Note: The instructions for installing and connecting fiber main modules (FMMs) in the OIU chassis are not in the scope of this

document. For details, refer to the quick installation sheet provided with the module.

REQUIRED KITS

The following kits are required for installing the OIU. If any of the listed items are missing, contact your Corning

representative.

OIU Kit

OIU Chassis (with blank panels) —

with factory-assembled FAM and rack brackets

Fan Module (FAM) — one unit hosting four fans

(factory installed in chassis rear)

RJ45 100 Base-T Ethernet Communication Cable,

L = 2-2.15 m (P/N: 705900003) — ACM management

connection

Table 1. Kits Required for OIU Installation

Corning Optical Communications

Optical Interface Unit (OIU)

Quick Installation Sheet

CMA-263-AEN

GENERAL INFORMATION

• OIMe —optical module only; fiber jumper is not included —

compatible MTP®-LC APC harness cable is ordered separately

(see Section 2 of this document)

• OIU chassis is supplied empty and only includes the factory-assembled

fan module (FAM). All other modules (i.e., power supplies, controller,

OIMe, OIXs, and FMMs) are ordered separately and must be installed.

Qty

Item

Quick Installation Sheet | CMA-263-AEN | Page 1